Price: $18.99 - $15.99
(as of Mar 26,2024 06:42:58 UTC – Details)
- The power tester has no battery and is completely powered by 20-pin or 24-pin interface, if there is no 20-pin or 24-pin interface powered, tester screen will not light up and the value cannot be read.
- The Product Screen Has Scratches？Because the LCD screen is easy to scratch, we put aprotective film on It, if you think It's not beautiful and useless, you can tear it off by yourself.
- The protective film of the screen fits very well and is not easy to tear off. Please operate carefully to avoid scratching the LCD screen.
- Please do not plug the interface in the wrong position or reverse, which may cause the power tester to smoke or damage your power supply.
- Special reminder: not supported Hot Plug, Hot Plug behavior can cause short circuits or other problems
[8-in-1 ATX Power Supply Tester] — Support test 20-pin ATX / 24-pin ATX / HDD (IDE) / Floppy 4-pin / PCI-e 6-pin / 4-pin / EPS 8-pin (NOTE: can not fit for PCI-e 8-pin) / SATA connectors
[Aluminum Alloy Enclosure] — Light and Easy to Carry, High Strength, Nice Thermal Conductivity & Corrosion Resistance
[1.8” LCD Screen] — Outputted Voltages shows on the 1.8” LCD Screen, Easy to Read ( The 1.8” LCD Screen was Powered by 20-pin / 24-pin Connector ), Note: The Product Screen Has a Load of Scratches All Over It？Because The Screen is Easy to Scratch, We Put a Protective Film on It, If You Think It’s Not Beautiful, You Can Tear It Off by Yourself
[Beep Alarm] — When your power supply test value is beyond normal range, the Power Supply Tester would issue a buzzer alarm, Easy to Know
NOTE: The voltage of 20pin / 24pin connectors is displayed by the LCD Screen, as “+3.3V”, “+12V1”, “+5V”, “-12V”, “5VSB”, “PG” (except “+12V2” on LCD Screen); The voltage of PCI-e 6P / 4P / EPS P8 connectors is displayed by the LCD Screen as “+12V2”
NOTE: The voltage of IDE (HDD), Floppy, SATA connector is displayed by the lights on the left of the power tester, IDE (HDD) connector is displayed by “+12V” & “+5V” lights; Floppy connector is displayed by “+12V” & “+5V” lights; SATA connector is displayed by “+12V”, “+3.3V” & “+5V” lights
NOTE: When you test the SATA connector, please confirm how many wires your connector is. When the 5-wire SATA connector is normal, the tester will light up three LED lights “+12v”, “5V” and “+3.3v”. When the 4-wire SATA connector is normal, the tester will only light up two LED lights “+12v” and “+5v”
